Fluid Management 5G-HD Harbil 5-Gallon Shaker - Manual (Page 55)


Fluid Management Customer Service 1 . 800 . 462 . 2466 Harbil 5G Mixer | 53
Reassembling Mixer
Reassembling
Mixer
Two people are required to lift the shake frame into the mixer.
Reassembling Mixer Procedure
1. With one person on each side of the shake frame, lift the shake frame into
the mixer and rest it on the crankshaft.
Note: The 4 screw holes in the swivel rods must be properly
aligned with the holes in the inner frame. The second person
supports the top of the shake frame so it will no fall forward.
2. Place the washers on the screws and insert them into the swivel rods. Guide
the screws into the holes in the inner frame.
Note: The screws are inserted from the inside of the swivel rods.
3 . Place the nuts on the screws, but do not tighten them all the way. Repeat
steps #2 and #3 on the other side of the mixer.
4
. Before mounting the flange bearings, lubricate them with lithium-based
grease.
• Rotate the collar of the flange bearing so that the 2 set screws are facing
up, then place the flange bearing on the end of the crankshaft.
• Tighten the set screws holding the crankshaft to the flange bearing.
• Use the 2” x 4’ board to lift the shake frame in order to tighten the 4 nuts
securing the flange bearing to the shake frame.
• Insert the screws from the inside of the shake frame, then place the
washers and nuts on the outside of the flange bearing and hand tighten.
5. Standing in front of the mixer, verify that the shake frame is centered inside
the inner frame. There must be equal clearance between the shake frame
and the inner frame on both sides of the mixer. Adjust if necessary.
6
. Tighten the 4 nuts and screws holding the swivel rods to the inner frame.
Insert the wrench on the inner side of the shake frame and tighten one screw
on the right and left sides. Again verify that the shake frame is properly
centered before tightening the other 3 nuts all the way on each side of the
mixer.
7. Reinstall the inner frame weights.