Fluid Management 5G-HD Harbil 5-Gallon Shaker - Manual (Page 25)


Fluid Management Customer Service 1 . 800 . 462 . 2466 Harbil 5G Mixer | 23
Troubleshooting
PROBLEM CHECK ACTION
The top plate does not move in an
upward direction.
 voltage at the DC motor.
 broken wire in the DC motor cabling.
 problem with the DC motor.
 problem with the UP switch
mechanism on the control panel.
 may be a problem with printed circuit
board.
• Use voltage meter or contact
Customer Service for assistance.
• Replace broken DC motor cabling.
• Contact Customer Service.
• Replace DC motor.
• See wiring schematic and test with
voltmeter.
• Replace the UP switch mechanism.
• Call Customer Service.
• Replace printed circuit board.
Paint mixer runs before the top plate
clamps on the container.
 binding of the top plate.
 may be a problem with printed circuit
board.
• Clean and oil lead screws.
• Call Customer Service.
• Replace printed circuit board.
Paint mixer will not shut off.  timer control on the front control
panel.
 if relay is stuck in the closed
position.
 bad timer.
 may be a problem with printed circuit
board.
• Replace if necessary.
• Replace relay.
• Replace timer.
• Call Customer Service.
• Replace printed circuit board.
The shake motor has voltage and
hums, but it will not run.
 low line voltage.
 V-belt tension.
 motor capacitor.
 shake motor.
• Confirm that the mixer is on a
dedicated line.
• Correct tension.
• Replace motor capacitor.
• Replace shake motor.