Removing shake frame – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 33
Fluid Management Customer Service 1 . 800 . 462 . 2466
Harbil 5G Mixer | 31
Removing Shake Frame
3.
With a 1/8” hex wrench, loosen the 2 set screws holding the crankshaft to
the flange bearings. Remove the flange bearings. If necessary, use a wheel
puller to pry the flange bearing from the crankshaft.
•
CAUTION
Be careful when removing the shake frame. It may swivel
or fall forward while working on the next step.
•
CAUTION
Be careful when lifting. The shake frame weighs over 200
pounds.
4.
Position one person at the back of the mixer to hold the shake frame. Using
a 1/2” socket or open-end wrench, remove the 2 nuts and screws holding the
swivel rods to the inner frame.
Figure 9. Nuts and Screws Holding Swivel Rods
5.
Repeat steps 2 – 4 on the other side.
6.
With the assistance of another person, lift up and pull out the complete
shake frame.
hex nuts
Shake Frame
flathead
cap screws
Swivel Rod