Removing shake frame – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 30
28 | Harbil 5G Mixer
Fluid Management Customer Service 1 . 800 . 462 . 2466
Removing Shake Frame
Some service procedures involve removing the shake frame. Read all of the
following instructions. If you have any doubt about performing these procedures,
please contact Customer Service at Fluid Management. For component identification
and location, refer to the Parts Section of this manual.
Removing Shake Frame Procedure
1.
Remove the sheet metal covers (see OPENING THE MIXER, page 27).
2.
To facilitate the reassembly process, mark or prepare a drawing of the
2 wires running from the left side of the terminal block to the control box.
3.
Using a small blade screwdriver, disconnect the 2 wires.
4.
Pull the cable containing the 2 wires through 2 tie wraps, or snip and remove
the tie wraps with side cutters.
Figure 6. Disconnecting the 4 Wires at the Terminal Block
Removing
Shake Frame
black
red
red
black