Replacing super-struts – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 50
Advertising
48 | Harbil 5G Mixer
Fluid Management Customer Service 1 . 800 . 462 . 2466
3.
Repeat Step 1 for the FRONT strut. Install the new strut pins, washers,
rubber grommets, and top nuts on the inner frame as shown in the figure
below. Hand tighten until snug.
Figure 20. Replacing the Front Strut
4.
Using the 2” x 4’ board, lift the inner frame and install both springs on the
strut bodies, then remove the blocks from under the inner frame.
5.
Lift the inner frame again with the 2” x 4’ board as a lever. This will allow you
to align and insert the strut pins into the strut bodies.
Note: Use care when installing the pins in order to prevent damage
to the inner bushing.
Replacing Super-Struts
Advertising