Fluid Management 5G-HD Harbil 5-Gallon Shaker - Manual (Page 52)

50 | Harbil 5G Mixer

Fluid Management Customer Service 1 . 800 . 462 . 2466
Please read all the directions before attempting this procedure. If you do not feel
comfortable about disassembling the mixer or replacing a part, please do not attempt
it. Should questions arise, contact Customer Service at Fluid Management.
Turn to the Parts Section for component identification and location.
Access the Crankshaft
1. Unplug the electrical cord.
2. Remove the sheet metal covers. Refer to “OPENING THE MIXER”, page 27.
3.
Remove the shake frame and counterweights. Refer “REMOVING SHAKE
FRAME” on page 27.
Remove the Crankshaft
1. Using two 1/2” wrenches, loosen the 4 nuts and screws holding the motor to
the inner frame.
Figure 22. Removing the Crankshaft
Replacing
Crankshaft
Replacing Crankshaft
Pillow Block
Bearing Screws
Motor Mounting
Screws and Nuts (4)