Opening the mixer, Remove exterior panels – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 29
Fluid Management Customer Service 1 . 800 . 462 . 2466
Harbil 5G Mixer | 27
Opening the Mixer
Remove Exterior Panels
1.
Using a medium-size screwdriver or 1/4” nut driver, remove the sheet metal
screws securing the top cover. Lift it off the mixer.
Figure 5. Removing the Mixer Covers
2.
In the same manner, take off the upper rear cabinet (3-sided piece) covering
the sides and back, and set to the side of the work area.
3.
If your machine has a 4-sided skirt, remove it now.
4.
At the back of the mixer, squeeze the power supply strain relief with a pair of
pliers, and pull it off the cord. Move the back panel away from the machine
(the cord will still be attached).
5.
Remove the right and left side panels, and the lower front panel.
6.
To prevent damage, remove the mixer door by lifting the door off its pins.
7.
Cut the upper wire tie wrap securing the 3 cables to the outer frame at the
left side of the machine.
8.
Remove the remaining front sheet metal covering. Carefully prop the front
piece (two front columns with control box assembly) to the side of the
machine, being careful to not damage the cords.
Opening the
Mixer
Top Cover
sheet metal screw
Upper Rear Cabinet
Lower Rear Cabinet
(not shown)
Right / Left Side Panel
Front Panel
Front Cover
(stainless steel)
Front Door
Control Box Assembly