Replacing super-struts – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 51
Fluid Management Customer Service 1 . 800 . 462 . 2466
Harbil 5G Mixer | 49
Replacing Super-Struts
6.
Make sure that the springs are centered. Push with your thumb to click them
into place.
Figure 21. Replacing the Strut Shafts
7.
Beginning with the FRONT strut, tighten the top nut until the bottom rubber
grommet is compressed 1/2”.
8.
Tighten the BOTTOM screw until the top rubber grommet is also
compressed to 1/2”.
9
. Moving to the REAR strut, tighten the TOP nut until the bottom rubber
grommet is compressed 1/2”.
10.
Insert the 1/8” hex wrench into the strut pin and tighten the BOTTOM screw
until the top rubber grommet is compressed to 1/2”. Remove the hex wrench
from the strut pin.
11.
To change the struts on the other side of the mixer, repeat these steps
beginning with Step 1 under “Removing the Super-Struts”, page 44.
Strut Grommet
Strut Pin