Reassembling mixer – Fluid Management 5G-HD Harbil 5-Gallon Shaker User Manual
Page 56
54 | Harbil 5G Mixer
Fluid Management Customer Service 1 . 800 . 462 . 2466
Reassembling Mixer
8
. Thread the grey control box cable through the hole in the shake frame and
through the tie wraps. If the tie wraps were removed, install new ones.
9
. Tighten the strain relief.
10
. Using your wiring diagram, connect the 4 wires leading from the grey cable
to the shake frame terminal block.
11
. Reposition the sheet metal covering and secure with the sheet metal screws.
If using a ratchet, do not apply too much pressure to the self-drilling sheet
metal screws.
12
. Place the door in its proper position.
13
. Secure the top cover.
Test Procedure
1
. Push the shake frame vertically and horizontally back and forth to verify
freedom of motion.
2
. Plug in the mixer.
3
. Place a gallon can of paint in the mixer.
4
. Turn on the mixer to verify that it is working properly. Make any necessary
adjustments.
5
. Dispose of remaining used parts.