2N Omega Lite - Configuration Tool manual v1.6 - Manual (Page 61)

2N
®
- OMEGA Lite
Configuration instrument
User’s manual – configuration instrument
61
www.2n.cz
or until the incoming ringing from an external line
DISA
Number of voice from
1 to 10 = 0
Or nothing
Stops previous ringing to internal lines and
takes an external line to wait for a fax or
modem call or DTMF number
DISA End None Ends dialling detection
Voice
Number of voice from
1 to 9
Plays the voice
Select tone A selection of tones
After lifting an external line with the DISA
service activated a different tone can be
imposed (for special applications)
Table Number of ringing table Ringing tables can be catenated
Automatic
operator
Automatic operator’s
number 0-8
Rings a given automatic operator voice
system. If module not working then it carries
on with next row in table.
Connect remote
access
None
Rings the remote access modem in the PBX.
If the module is not installed then it carries on
with next row in table.
Transit DID
VL, SYS number or
virtual
Carries out a start up on the bundle for
outgoing lines to the VTS by parameter. This
allows an outgoing call to be made from
within the PBX on the line account given by
the parameter.
Call fast dialling
The number or name of
the joint fast dialling
After an incoming external call it dials the
given fast dialling. Which line the call will be
charged to and which lines it will go to the
VTS is determined in the settings External
lines/Identification for transit calls.
Hang up None
Hangs up on an external line and ends all
actions. It is in the last row and cannot be
removed.
Go to line Row number Jumps to the selected ringing table row.
Announce
through
broadcast
Voice message
Connects the AUX assigned to the
Broadcast service, plays the voice message
and the AUX Broadcast remains connected
until hang-up or the Terminate broadcast
service activation.
GSM DTMF test None
While calling to a module equipped with
DTMF detectors (designated as OL2GSMD,
OLGFAX at 2N), you can dial the DTMF
characters during ringing that are displayed
on the PBX.
Attention: The total number of rows in all of the ringing tables cannot exceed 500.