2N Omega Lite - Configuration Tool manual v1.6 - Manual (Page 63)

2N
®
- OMEGA Lite
Configuration instrument
User’s manual – configuration instrument
63
www.2n.cz
Action Parameter
Wait 4
DISA 1
Wait 6
DISA End
Call VL 12
Call VL 13
Wait 20
Call operator
Wait 30
Don’t call
Voice 3
Call voicemail 11
Wait 90
Hang up
Tab. 5
Action
Parameter
Call accessible
lines
Call VL 19
Wait 20
DISA 1
Wait 6
DISA End
Call VL 12
Call operator
Wait 30
Don’t call
Voice 2
Hang up
Tab. 6
Tab. 7
Action Parameter
Wait 2
Call VL 15
Wait 0
Hang up
Example 7: Using CLIP support, ringing from
an external line is directed to internal line 15.
The time it rings on line 15 is not influenced
by the ringing table and is controlled by the
settings in line 15. For this case it is most
important to prearrange the command Wait
with the parameter 2 secs before the actual
command Call VL with the parameter 15.
Example 5: During an incoming call after 4
secs the external line is picked up, it waits for
the DISA or fax dial tone with the voice signal
number 1. After it subsides it waits another 6
secs and if the DID does not come then it rings
for 20 secs on lines 12 and 13. Afterwards it
forwards the call to the operator and if no one
takes the call after 30 secs it records voice 3
(e.g. you will be connected to the answer
phone), it connects to the answer phone on line
19 and if the answer phone does not accept the
call then it hangs up after 90 secs.
Example 6: Delayed DISA. During an
incoming ringing it rings for 20 secs on the
accessible lines and line 19. If no one picks
it up, then it picks up the external line then it
awaits the DISA or fax DID with the voice
signal number 1. After the signal subsides it
waits 6 secs and if a DID does not come in
that time it rings line 12 and the operator for
30 secs. If no one takes the call in this time
it plays voice 2 to the subscriber and hangs
up.