Lubrication and maintenance, Lubrication, Lubrication symbols – Kinze 3600 Lift and Rotate Planter Rev. 7/14 User Manual
Page 109: Sealed bearings, Wrap spring wrench assembly, Air clutch lubrication, Lubrication -1, Lubrication symbols -1, Sealed bearings -1, Wrap spring wrench assembly -1
Lubrication and Maintenance
Following pages show locations of all lubrication points. Proper lubrication of moving parts helps ensure efficient
operation of your Kinze planter and prolongs the life of friction producing parts.
"-20 x ½" cap screw securng idler assembly to
wrap spring wrench tightener shaft and
2. Remove wrap spring wrench from planter.
3. Tip wrap spring wrench on its side and lubricate with a
high quality spray lubricant. Lubricant must be absorbed
into wrap spring area.
4. Reinstall wrap spring wrench on planter.
WRAP SPRING WRENCH ASSEMBLY
Wrap spring wrench lubrication
Sealed bearings are used on your Kinze planter to provide
trouble free operation.
These are located on drive shafts, row units, and transmission
bearings. Sealed bearings are lubricated for life and are not
Lubricate at frequency indicated
with SAE multipurpose grease.
Lubricate at frequency indicated with high
quality SAE 10 weight oil or spray lubricant.
Sealed bearing (Typical)
AIR CLUTCH LUBRICATION
Lubricate air clutches every 75-100 hours.
Remove Phillips head screw and spray a 1-2 second burst of
silicone spray into each clutch. Reinstall screw.
Air clutch lubrication