Kinze 3600 Lift and Rotate Planter Rev. 7/14 - Manual (Page 21)

TM
Model 3600 M0236-01
Rev. 5/13 2-11
Machine Operation
HALL EffECT SENSOR
(HYDRAULIC DRIVE ONLY)
HYDRAULIC SEED RATE DRIVE
Refer to Ag Leader Integra or KINZE Cobalt operation manuals for information on setting and controlling hydraulic seed
rate system.
Set Hall effect sensor within ⅛" of pick-up disc.
Hall effect sensor
Dry fertilizer attachment transmission Transmission shaft
Shear pins protect planter driveline and row unit components from damage.
1. Determine where binding has occurred before replacing a pin. Turn shaft by hand (with the aid of a wrench) and
check for misalignment and seized parts.
2. When shaft can be turned by hand (with the aid of a wrench) replace shear pins with same size and type. Spare
shear pins are stored inside ends of rear planter frame.
NOTICE
Misaligned drill shaft/transmission coupler can cause equipment damage.
3. Check driveline alignment and follow prescribed lubrication schedules to prevent component binding or breakage.
SHEAR PROTECTION
3∕16 " shear pin 3∕16 " shear pin
HYDRAULIC WEIGHT TRANSfER TOOLBAR
The hydraulic weight transfer is standard on bulk fill equipped machines and optional on conventional hopper machines.
The bulk fill hydraulic system powers the hydraulic weight transfer system and conventional hopper system requires an
additional SCV. Pressure is set from the factory and does not require additional adjustment.