Kinze 3600 Lift and Rotate Planter Rev. 7/14 - Manual (Page 15)

TM
Model 3600 M0236-01
Rev. 7/11 2-5
Machine Operation
TRACTOR PREPARATION AND HOOKUP
1. Adjust tractor drawbar 13-17 inches above ground with hitch pin hole directly below PTO shaft center line. Make
sure drawbar is in a stationary position.
2. Install control console on tractor in a convenient location within easy reach of operator and close to hydraulic
controls. Mount control console securely and route power cord to power source.Control console operates on
12 volt DC only. If two 12 volt batteries are connected in series, ALWAYS make power connection on battery
grounded to tractor chassis.
If two 6 volt batteries are connected in series, make sure power connection provides 12 volt DC across positive
terminal on one battery and negative terminal of second battery.
3. Back tractor to planter and connect with 1¼" - 1½" diameter hitch pin. If tractor is not equipped with a hitch pin
locking device, make sure hitch pin is secured with a locking pin or cotter pin.
Planter/safety chain hookup to tractor Optional 2-point hitch
NOTE: DO NOT install safety chain using clevis mounting hardware. Safety chain MUST be installed
separately.
4. Safety chain must be used to keep planter and tractor connected in case of a hitch pin/drawbar failure. Attach
safety chain at an unused clevis mounting hole on the planter hitch. Torque hardware to 840 ft-lb (1138.8 N-m).
NOTE: A 2-Point Hitch Option converts planter from drawn to semi-mounted and is available for use with
Category 3N or 3 three-point hitch designs. Safety chain is not used with 2-point hitch.
WARNING
Pressurized hydraulic fluid can penetrate body tissue and result in
death, serious infection, or other injuries. fluid injected under skin
must be IMMEDIATELY removed by a surgeon familiar with this
type of injury. Make sure connections are tight and hoses and
fittings are not damaged before applying system pressure. Leaks
can be invisible. Keep away from suspected leaks. Relieve pressure
before connecting or disconnecting tractor, searching for leaks, or
performing any system maintenance.
NOTICE
Wipe hose ends to remove any dirt before connecting couplers to
tractor ports or contamination may cause equipment failure.