Kinze 3600 Lift and Rotate Planter Rev. 7/14 - Manual (Page 114)

M0236-01 Model 3600
6-6 Rev. 7/11
TM
Lubrication and Maintenance
PTO PUMP SHAfT COUPLING (TRACTOR
MOUNTED PTO PUMP AND OIL COOLER)
NOTE: Clean and grease PTO shaft coupling each time
pump is installed.
NOTE: Apply coating of high-speed industrial coupling
grease, such as Chevron
® Coupling Grease, that meets
AGMA CG-1 and CG-2 Standards to extend shaft spline
life.
Chevron ® trademark is owned by Chevron Products Company.
AGMA is the acronym for the American Gear Manufacturers
Association. 1⅜"-21 spline PTO pump shown
WHEEL BEARINGS
All drive, transport, and marker hub wheel bearings should be repacked annually and checked for wear.
1. Raise wheel off ground.
2. Check for bearing endplay by moving wheel side to side.
3. Rotate wheel to check for bearing roughness. If bearings sound rough, remove hub and inspect bearings.
NOTE: To repack wheel hubs, follow procedure outlined for wheel bearing replacement except bearings and
bearing cups are reused.
GREASE fITTINGS
Parts equipped with grease fittings should be lubricated
at frequency indicated with an SAE multipurpose grease.
Clean fitting thoroughly before using grease gun. Frequency
of lubrication recommended is based on normal operating
conditions. Severe or unusual conditions may require more
frequent attention.
Row marker assemblies - 3 per assembly Center Pivot - 1