Kinze 3600 Lift and Rotate Planter Rev. 7/14 - Manual (Page 14)

M0236-01 Model 3600
2-4 Rev. 7/11
TM
Machine Operation
TRACTOR REqUIREMENTS
Consult your dealer for information on horsepower requirements and tractor compatibility. Requirements vary with
planter options, tillage, and terrain.
A 12 volt DC electrical system is required on all sizes.
A minimum of two SCV remote hydraulic outlets are required on all sizes. One SCV is used for field lift and with a
control console switch operates raise to transport function. A second SCV using control console operates row markers
fold/unfold functions. Additional SCV's with a zero pressure case drain are needed for EdgeVac vacuum fan motor for
seed metering system Air Seed Delivery, Hydraulic Drive, and Wing Down Pressure (if installed without EdgeVac or
ASD).
Maximum hydraulic flow rate of 13 GPM @ 2000 PSI is required to operate EdgeVac vacuum fan motor.
The tractor mounted PTO pump and oil cooler option is for
tractors with less than required hydraulic output needed
to operate hydraulic-driven vacuum fan and other planter
hydraulic requirements.
A 1000 RPM PTO is required to operate the PTO-driven
hydraulic pump.
PTO pump option consists of a 1⅜"-21 or 1¾"-20 spline 13.5
GPM 2000 psi tractor mounted pump, planter mounted 10
gallon capacity hydraulic reservoir with spin-on 10-micron
oil filter, EdgeVac fan mounted 15 GPM-rated oil cooler, and
required hydraulic valves, fittings, and hoses.
Vacuum fan assembly
Oil cooler
Hydraulic
motor
TRACTOR MOUNTED PTO PUMP AND OIL COOLER OPTION
PTO-driven hydraulic pump
(1⅜" spline PTO pump shown)
Flow control valve
Oil filter
(10 Micron)
Reservoir
Hydraulic reservoir, flow control valve, and fittings