Lenze 8400 motec Manual - Manual (Page 111)

Accessories (overview)
Plug connectors
9
l
111 EDS84DG752 EN 4.0
9.2 Plug connectors
By default, cables for the connection of the mains and the motor are led into the WU by
means of cable glands. Alternatively, plug−in modules with prewired Q−plugs can be
supplied for mounting on the right or the left.
For plug−in modules with a Q−plug, an M16 bore for an additional cable gland is available.
Plug−in modules with two Q−plugs are designed for a looping−through connection
(daisy−chain). Like this it is possible to use a supply bus for the machine design.
In the case of wall mounting, the plug−in modules with a Q8−plug enable the motor
connection as a plug&drive drive, in particular with Lenze system cables.
In the table the retrofittable plug−in modules are listed.
;
.
X... U
max
I
max
IP
[V] [A]
E84DZEVBLANP ;
X10: Q5
400 ~ 16 ~
~
IP65
E84DZEVBRANP . £ E84DGDVB3024...
E84DZEVBLAFP ;
X10: Q5
X11: Q5 ~ ~
E84DZEVBRAFP . £ E84DGDVB3024...
E84DZEVBLPNP ;
X10: Q4/2
480 ~
24 =
32 ~
10 =
~=
E84DZEVBRPNP .
E84DZEVBLPRP
;
X10: Q4/2
X11: Q4/2
~= ~=
E84DZEVBRPRP .
E84DZEVBLCNP ;
X21: Q8 480 ~ −
E84DZEVBRCNP .