Lenze E94ASHExxxx - Manual (Page 73)

Technical data
General data and operating conditions
3

73 EDK94SH366 DE/EN/FR/ES/IT 3.1
3 Technical data
3.1 General data and operating conditions
Supply system data
Supply forms
With earthed neutral Unrestricted use
IT systems
Observe instructions about special measures!
Noise emission EN 61800-3 Cable-guided, up to 150 m motor cable length: category C2
Radiation: category C3
Noise immunity EN 61800-3 Category C3
Conformity and approval
Conformity
CE 73/23/EEC Low-Voltage Directive
Approval
UL UL 508C Power Conversion Equipment, File No. 132659
Protection of persons and devices
Enclosure
EN 60529 IP 20
Not in the wiring range of
the terminals on the
motor side
NEMA 250 Protection against contact to
type 1
Insulation resistance EN 61800-5-1 Overvoltage category III
Reduction from 2000 m amsl onwards: Overvoltage category
II
Insulation of control
circuits
EN 61800-5-1 Safe mains isolation by double/reinforced insulation.
Short-circuit strength EN 61800-5-1 Motor connection: with restrictions, fault acknowledgement
required
Control connections: without restrictions
Motor protective
measures against
z Short circuit
z
Earth fault
z Overvoltage
z Motor stalling
z
Motor overtemperature
(PTC or thermal contact, I 2 t monitoring)
Discharge current EN 61800-5-1 > 3.5 mA Observe regulations and
safety instructions!
Cyclic mains switching Cyclic mains switching of 5-times in 5 minutes permissible
without restrictions.
Environmental conditions
Climate
Storage IEC/EN 60721-3-1 1K3 (-25 ... +60 °C)
Transport IEC/EN 60721-3-2 2K3 (-25 ... +70 °C)
Operation IEC/EN 60721-3-3 3K3 (-10 ... +55 °C)
Power derating at +45 ... +55 °C: 1 %/°C
Site altitude 0 ... 4000 m amsl
Power derating at 1000 ... 4000 m amsl: 5 %/1000 m
Pollution EN 61800-5-1 Degree of pollution 2
Vibration resistance IEC/EN 60068-2-6
IEC/EN 60068-2-64
Sinusoidal: 0.7 g RMS, 20 ... 250 Hz
Noise: 0.7 g RMS, 20 ... 250 Hz