4 control terminals, Wiring the device – Lenze E94ASHExxxx User Manual
Page 97
Advertising
Wiring the device
Control terminals
5
97
EDK94SH366 DE/EN/FR/ES/IT 3.1
5.4
Control terminals
System bus CAN on board
Terminal X1
Labelling
Description
Pin 2
CAN-LOW
Pin 3
CAN-GND
Pin 7
CAN-HIGH
9400SSP000X1
(Housing)
CAN-Shield
Note!
The X1 connection is not available in the ”StateLine” design.
24 V supply
Terminal X2
Labelling
Description
GE
GND external supply
24E
24 V external supply via a safely separated power supply
unit (SELV/PELV) (only required for mains-independent supply of the
control electronics)
9400SSP000X2
SB
State bus in/out (reference GE)
Terminal data
Conductor cross-section
Tightening torque
[mm
2
]
[AWG]
[Nm]
[lb-in]
Flexible
0.2 ... 2.5
24 ... 12
Spring terminal
With wire end
ferrule
Advertising