Lenze CANopen control technology - Manual (Page 10)

Control technology | CANopen communication manual
About this documentation
Terminology used
10
L
DMS 4.2 EN 07/2011 TD17
1.3 Terminology used
Term Meaning
»Engineer« Lenze engineering tools supporting you during the entire life cycle of a machine
- from the planning phase to maintenance.
»Global Drive Control« (GDC)
»PLC Designer«
Code
"Container" for one or several parameters used for Lenze Servo Drives parameter
setting or monitoring.
Subcode If a code contains several parameters, they are stored in "subcodes".
In the documentation the diagonal slash "/" is used as a separator between the
designation of the code and subcode (e.g. "C00118/3").
IPC Industrial PC
PLC Programmable Logic Controller