Lenze CANopen control technology - Manual (Page 52)

Control technology | CANopen communication manual
Commissioning the CANopen Logic bus
Commissioning of field devices
52
L
DMS 4.2 EN 07/2011 TD17
8.3.6 Commissioning of 8200 vector frequency inverter

Parameter setting with the »Global Drive Control«
1. Start the »GDC«.
2. Start the search for controllers at the CANopen bus and select the found 8200
vector frequency inverter.
Or first select the suitable 8200 vector frequency inverter with fieldbus function
module CANopen (E82ZAFUCxxx) offline and then go online.
3. Parameterise the inverter.
4. Save the parameter set with mains failure protection.
5. Go offline.

Note!
• For CAN communication, plug on the fieldbus function module CANopen
(E82ZAFUCxxx).
• CAN settings must be made in the »PLC Designer« since the settings are
transferred from the control to the 8200 vector frequency inverter.