Lenze MC1000 Series - Manual (Page 29)

13435742_EDBM101_v24 25
13.2 MC1000 DISPLAY
The following describes the possible display configurations for the MC1000 Series
drive.
13.2.1 MC1000 DISPLAY IN STOP MODE
When the drive is in the STOP mode, there are three possible displays. The first is
the SPEED display, which looks like this:
STOP > 60.00 HZ
DRIVE
STATUS
SPEED
SET POINT
SPEED
UNITS
DIRECTION
(FORWARD)
NOTE: Refer to Parameter 31 - UNITS for the SPEED UNITS display options.
Pressing the ENTER key will change the display from the SPEED indication to the
% LOAD indication:
STOP > 0% LOAD
DRIVE
STATUS
PERCENT
LOAD
DIRECTION
(FORWARD)
Pressing the ENTER key again will change the display from the % LOAD indication
to the VAC (motor voltage) indication:
STOP > 0 VAC
DRIVE
STATUS
MOTOR
VOLTAGE
DIRECTION
(FORWARD)
Pressing ENTER again will change the display back to the SPEED indication.