Lenze MC1000 Series - Manual (Page 42)

38 13435742_EDBM101_v24
16 PROGRAMMING THE MC1000 DRIVE
16.1 PROGRAMMING THE PARAMETERS
The MC1000 keypad serves two purposes: operating the drive when in the LOCAL
mode, and programming the parameters for particular applications. The keypad
is shown below, along with the display that should appear when the drive is first
powered up:
PROG
STOP > 20.00 HZ
START
STOP ENTER
FWD
REV
AUTO
MAN RUN
To program the drive, the PROGRAM mode must be entered by pressing the PROG/
RUN button. If the password protection is disabled, pressing the PROG/RUN button
will result in direct entry into the PROGRAM mode. If the password protection is
enabled, the PASSWORD prompt will appear when an attempt is made to enter the
PROGRAM mode. The PASSWORD prompt appears as follows:
PASSWORD 0000
CURSOR
To enter the password, use the UP and DOWN arrow keys to scroll to the password
value, and then press the ENTER key.
NOTE:
The factory default password is 0019.