Lenze MC1000 Series - Manual (Page 31)

13435742_EDBM101_v24 27
RUN > 460 VAC
DRIVE
STATUS
MOTOR
VOLTAGE
DIRECTION
(FORWARD)
NOTE: During acceleration and deceleration to the SPEED SET POINT, the DRIVE
STATUS will show the actual drive speed. When the SPEED SET POINT is reached,
the DRIVE STATUS will change to RUN (or STOP if the drive is decelerating to a
STOP).
13.2.3 MC1000 DISPLAY IN FAULT MODE
When the drive trips into a fault, the display will automatically change to the FAULT
display, which indicates the FAULT MESSAGE:
FAULT: OVERLOAD
DRIVE
STATUS
FAULT
MESSAGE
In FAULT mode, the ENTER key will toggle the display between four screens:
FAULT, SPEED, % LOAD and VAC. The DRIVE STATUS for these displays will
be FAULT. An example is shown below of the drive in the FAULT mode displaying
SPEED.
FAULT > 60.00 HZ
DRIVE
STATUS
SPEED
SET POINT
SPEED
UNITS
DIRECTION
(FORWARD)
NOTE: To clear a FAULT, press the STOP key, issue a remote STOP command at
TB-1, or use TB-13D (refer to Parameter 50 - TB13D).