Lenze MC1000 Series - Manual (Page 43)

13435742_EDBM101_v24 39
Once the correct password is entered, the PROGRAM mode will be entered and
the first parameter will be displayed, which is Parameter 0 - LINE VOLTS. This is
shown below:
LINE VOLTS AUTO
PARAMETER
NAME
PARAMETER
VALUE
CURSOR
To scroll through the parameters, use the UP and DOWN arrow buttons on the
keypad. When the desired parameter is found, press the ENTER key to shift the
cursor from the parameter name to the parameter value. In this example, the cursor
shifts from LINE VOLTS to AUTO:
LINE VOLTS AUTO
PARAMETER
NAME
PARAMETER
VALUE
CURSOR
The parameter value can then be changed using the UP and DOWN arrow buttons.
If the parameter has a numerical value, the UP arrow will increase the value and the
DOWN arrow will decrease the value. If the parameter has specific choices that can
be selected, the UP and DOWN arrow keys will scroll through the list of possible
settings. When the desired value or option is selected, press the ENTER key to
store the new setting. If the new setting is not ENTERED, it will not take effect and
the old setting will still be valid.
If the PROG/RUN key is pushed while the cursor is highlighting the parameter value,
the value will change back to the original setting (if it had been changed, but not
ENTERED), and the cursor will shift back to the parameter name. Pressing PROG/
RUN again will exit the PROGRAM mode. If the PROGRAM mode is entered again
within two minutes, the last parameter that was viewed, or changed, will come up
on the display. After two minutes has elapsed, the password will have to be entered
again when attempting to access the PROGRAM mode.