Lenze E84DxxxxxxxxxR - Manual (Page 12)

Communication manual 8400 protec PROFINET
General information
12
L
EDS84DPNET EN 4.0 - 11/2010
Properties of the PROFINET with Inverter Drives 8400 protec
 Support of the I&M0 ... 4 functionality for the identification of the Inverter Drive 8400
protec
 Transmission of safe information via the PROFIsafe protocol when using a version with
an integrated safety system
 Up to 16 process data words can be exchanged for each direction.
 Automatic detection of the baud rate 100 Mbps
 A line topology is enabled by the integrated 2-port switch.
 Support of the LLDP (Link Layer Discovery Protocol) for the topology recognition
 Support of the SNMP (Simple Network Management Protocol) for diagnostics
 Support of the MRP (Media Redundancy Protocol)
– The Inverter Drive 8400 protec can be integrated into a ring topology as a client node.
 Device replacement without exchangeable disk storage
– Since the "station alias" is supported, a station name is automatically assigned to the
new PROFINET node.
– For storing the parameters of the controller, a memory module is still required.
 Access to all Lenze parameters

Safety engineering manual "Inverter Drives 8400 protec"
Here you can find detailed information on devices with an integrated safety
system.