Lenze E84DxxxxxxxxxR - Manual (Page 75)

EDS84DPNET EN 4.0 - 11/2010
L
75
Communication manual 8400 protec PROFINET
Parameter reference
Parameters relevant for communication
C13880
C13881
C13885
Parameter | Name:
C13880 | Reaction on communication failure
Data type: UNSIGNED_8
Index: 10695
d
= 29C7
h
The action set in subcode 1 of the code is carried out when the node recognises that it is no longer in the
DATA_EXCHANGE status.
• Please also observe the notes in code C13881 .
• A change in the monitoring response becomes immediately effective.
Selection list
0 No response
1 Error
3 Quick stop by trouble
4 Warning locked
6 Information
Subcodes Lenze setting Information
C13880/1 0: No response "Watchdog/Data Exchange" monitoring
; Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
Parameter | Name:
C13881 | Reaction time delay
Data type: UNSIGNED_16
Index: 10694
d
= 29C6
h
If the DATA_EXCHANGE status is exited, the response parameterised in C13880 is activated after the time set here
has elapsed.
• The value = 65535 in this code deactivates monitoring.
• A change in the monitoring mode becomes immediately effective.
Setting range
(min. value | unit | max. value) Lenze setting
0 ms 65535 0 ms
; Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT
Parameter | Name:
C13885 | Clear process data
Data type: UNSIGNED_8
Index: 10690
d
= 29C2
h
This code is used to set the process data that are to be processed by the IO device in order to maintain the internal
communication when the PROFINET has left the DATA_EXCHANGE status.
Selection list
(Lenze setting printed in bold) Information
0 Use of most recent master PDOs The last data sent by the IO controller are used.
1 PDOs are set to the value'0' The contents of the process data are set to the value "0".
; Read access ; Write access CINH PLC-STOP No transfer PDO_MAP_RX PDO_MAP_TX COM MOT