Rockwell Automation 20-750-CNETC PowerFlex Coaxial ControlNet Option Module - Manual (Page 13)

Rockwell Automation Publication 750COM-UM003B-EN-P - November 2012 13
Getting Started Chapter 1
Understanding Parameter
Types The option module has two types of parameters:
•
Device parameters are used to configure the option module to operate on
the network.
•
Host parameters are used to configure the option module Datalink transfer
and various fault actions with the drive.
You can view option module
Device parameters and Host parameters with any of
the following drive configuration tools:
• PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM—use the or
key to scroll to the drive port in which the module resides, press the
(Folders) key, and use the or key to scroll to the DEV
PARAM or HOST PARAM folder.
• Connected Components Workbench software—click the tab for the
option module at the bottom of the window, click the Parameters icon in
the tool bar, and click the
Device or Host Parameters tab.
• DriveExplorer software—find the option module in the treeview and open
its Parameters folder.
• DriveExecutive software—find the option module in the treeview, expand
the module in the tree, and open its Parameters folder.
Compatible Products At the time of publication, the option module is compatible with the following
products:
Required Equipment Some of the equipment that is required for use with the option module is shipped
with the module, but some you must supply yourself.
Equipment Shipped with the Option Module
When you unpack the option module, verify that the package includes the
following:
• PowerFlex 753 drives (all firmware revisions)
• PowerFlex 755 drives (all firmware revisions)
❑ One 20-750-CNETC Coaxial ControlNet Option Module
❑ One Network Communication Option Module Installation Instructions,
publication 750COM-IN002