Rockwell Automation 20-750-CNETC PowerFlex Coaxial ControlNet Option Module User Manual
Page 47
Rockwell Automation Publication 750COM-UM003B-EN-P - November 2012
47
Configuring the I/O
Chapter 4
2.
Click the Drive tab.
3.
Click Connect to Drive to begin the correlation process.
After the drive configuration data has been verified, a pop-up dialog box
appears, which synchronizes ports from the online drive to the project to
be sure that the correct Datalinks are assigned.
4.
Click OK.
If the Differences Found dialog box appears—which is typical, click
Download. This will download the project settings from the controller to
the drive and its connected option module. If Upload is clicked, the drive
and option module settings are uploaded to the controller.
5.
The I/O Configuration Differences dialog box appears.
TIP
On subsequent connections to the drive (after the initial download),
click Upload.