Rockwell Automation 20-750-CNETC PowerFlex Coaxial ControlNet Option Module - Manual (Page 20)

20 Rockwell Automation Publication 750COM-UM003B-EN-P - November 2012
Chapter 2 Installing the Option Module
Applying Power
Apply power to the drive. The option module receives its power from the drive.
When you apply power to the option module for the first time, its topmost
‘PORT’ status indicator should be steady green or flashing green after an
initialization. If it is red, there is a problem. See
Chapter 7 , Troubleshooting.
Start-Up Status Indications
After power has been applied, the drive STS (status) indicator can be viewed on
the front of the drive and the option module status indicators can be viewed with
the drive cover open or removed (
Figure 3 ). Possible start-up status indications
are shown in Table 1 .
Figure 3 - Drive and Option Module Status Indicators
ATTENTION: Risk of equipment damage, injury, or death exists. Unpredictable
operation may occur if you fail to verify that parameter settings are compatible
with your application. Verify that settings are compatible with your application
before applying power to the drive.
➊
➋
➌
➎
0
5 4
9 3 8 2 7
1
6
0
5 4
9 3 8 2
7
1
6
➍
See Table 1 for
possible start-up
status indications.
Drive Control Pod
(drive shown with cover removed)