Rockwell Automation 20-750-CNETC PowerFlex Coaxial ControlNet Option Module User Manual
Page 56
56
Rockwell Automation Publication 750COM-UM003B-EN-P - November 2012
Chapter 4
Configuring the I/O
2.
Click Download to download the configuration to the controller.
When the download is successfully completed, RSLogix 5000 software
goes into the Online mode and the I/O Not Responding box in the upper-
left of the screen should be flashing green.
3.
From the File menu, choose Save.
If this is the first time you saved the project, the Save As dialog box appears.
a. Navigate to a folder.
b. Type a file name.
c. Click Save to save the configuration as a file on your computer.
4.
Configure any Datalinks in the drive that were enabled in the controller
and option module during I/O configuration.
Each Datalink being used must be assigned to a specific parameter in the
drive or connected peripheral (see
Setting a Master-Slave Hierarchy
). If this is not done, the controller will receive or
send placeholder data instead of actual drive or peripheral parameter
values.
5.
Place the controller in Remote Run or Run Mode.
6.
Use the procedure in the next subsection
Use RSNetworx for ControlNet
Software to Configure and Save the I/O to the Bridge
to do the following:
•
Change the I/O Not Responding box in the upper-left of the RSLogix
5000 window from flashing green to steady green.
•
Remove the yellow warning symbols in the treeview under the I/O
Configuration folder and drive profile.
Use RSNetworx for ControlNet Software to Configure and Save the I/O to the Bridge
After configuring the I/O in the controller and drive, you must now download
and save these configurations to the bridge. This will also resolve the I/O Not
Responding box and the yellow warning symbols
in the RSLogix 5000
project.
1.
Start RSNetWorx for ControlNet software.
2.
From the File menu, choose New to display the New File dialog box.
3.
Select ControlNet Configuration as the network configuration type.
4.
Click OK.
5.
From the Network menu, choose Online to display the Browse for
Network dialog box.