Rockwell Automation 193-EDN E1Plus Overload Relays - DeviceNet Module - Manual (Page 25)

1 Publication 193-UM006A-EN-P – October 2005
Chapter
4
Device Parameters
Introduction This chapter describes each programmable parameter and its function.
Parameter Programming Refer to Chapter 3: DeviceNet Node Commissioning for instructions on using
RSNetWorx for DeviceNet to modify parameter settings.
Program Lock
Parameter 24, Program Lock, provides a degree of security from having
parameter settings unintentionally altered when programmed to the “locked”
setting.
Resetting to the Factory Default Values
Parameter 25, Set to Defaults, allows the installer to reset all parameter settings
(including trip logs) to the factory default values.
IMPORTANT
Parameter setting changes downloaded to the DeviceNet
Module take effect immediately even during a “running”
status.
IMPORTANT
Parameter setting changes made in a configuration tool,
such as RSNetWorx for DeviceNet, do not take effect in
the DeviceNet Module until the installer applies or
downloads the new settings to the device.
IMPORTANT
Resetting to factory default values also resets the
DeviceNet Module’s DeviceNet node address (MAC ID) to
the default value of 63.