Rockwell Automation 1788-CN2DN ControlNet-to-DeviceNet Linking Device Installation Instructions - Manual (Page 11)

ControlNet-to-DeviceNet Linking Device 11
Publication 1788-IN052D-EN-P - February 2007
3. Clip each of the end anchors onto the DIN rail next to the
CN2DN device.
4. Slide each anchor against the device and tighten the screws on
the front of the end anchor.
DIN Rail
Clip On
End Anchor onto DIN Rail
Slide the Anchor
Against the
CN2DN Device
Tighten the Clamping Screws
End Anchors Next to Device
Grounded DIN Rail