Rockwell Automation 1788-CN2DN ControlNet-to-DeviceNet Linking Device Installation Instructions - Manual (Page 19)

ControlNet-to-DeviceNet Linking Device 19
Publication 1788-IN052D-EN-P - February 2007
The resistor should bridge the blue and white terminal
cavities.
6. Tighten all of the terminal screws using 0.6 Nm (7 in-lb)
torque.
You have completed connecting to the DeviceNet network.
Uninstall the CN2DN Linking Device
Complete the following steps to uninstall the CN2DN linking device.
1. Remove power from the CN2DN device.
2. Disconnect the power, DeviceNet, and ControlNet connectors.
3. If end anchors are in place, remove by loosening the screws
and unclipping the anchor from the DIN rail.
121
Ω
41827
Resistor
Black
Blue
Bare or Shield
White
Red