Rockwell Automation 1794-IF4I, -OF4I, IF2XOF2I, -IF4IXT, -IF4ICFXT, -OF4IXT, IF2XOF2IXT FLEX I/O Isolated Analog Modules - Manual (Page 20)

Publication 1794-6.5.8 - January 2010
20 How to Install Your Analog Module
Panel/Wall Mounting
Installation on a wall or panel consists of:
•
laying out the drilling points on the wall or panel
•
drilling the pilot holes for the mounting screws
•
mounting the adapter mounting plate
•
installing the terminal base units and securing them to the wall
or panel
If you are installing your module into a terminal base unit that is
already installed, proceed to “Mounting the Analog Module on the
Terminal Base” on .
Use the mounting kit Cat. No. 1794-NM1 for panel/wall mounting.
1794-NM1 Mounting Kit
Contents:
1 ± Mounting Plate for Adapter
2 ± 18 #6 self-tapping screws
(2 for the adapter, and 2
each for up to 8 modules)
Adapter Module
(not included)
Terminal Base Unit
(not included)