8 - application examples, Application examples, Basic configuration example using the backplane – Rockwell Automation 1747-KE,D17476.12 DH-485/RS-232C Interface Module User Manual
Page 89: Parameter locations, Chapter 8, Basic configuration example using the backplane -1, Parameter locations -1, Chapter
1
Publication 1747-UM005B-EN-P - March 2006
Chapter
8
Application Examples
This chapter contains the following application examples.
• Basic configuration example using the backplane
• Supplementary examples using the backplane
• RSLinx software to SLC network via modem example
Basic Configuration
Example Using the
Backplane
This example demonstrates configuration of the interface module
using the backplane.
Parameter Locations
In this application, the configuration parameters are in the data file
N10.
Parameter Locations
IMPORTANT
Before you begin this application, insure that the
JW4 jumper is in vertical Run mode (module
configuration ID=3509).
Address
0
1
2
3
4
5
6
7
8
9
N10:00
0
0
0
0
0
0
0
0
0
0
N10:10
DF1 port configuration parameters
N10:20
DH485 port configuration parameters
N10:30
Modem Init String characters 1...14
N10:40
Modem Init String characters 15...28