Rockwell Automation 1771-DMC_DMC1_DMC4_DXPS Control Coprocessor User Manual - Manual (Page 25)

Chapter 2
Installing the Control Coprocessor
2-7
Install the control coprocessor in either direct-connect or standalone mode.
If you want to: Then select: On page:
Install a controlĆcoprocessor main module directly
connected to a PLCĆ5 programmable controller
DirectĆConnect Installation 2Ć7
Install the optional serial expander module Serial Expander
Module Installation
2Ć9
Install a control coprocessor in the same chassis
as, or remotely located from, a programmable
controller but not directly connected
Standalone Installation 2Ć10
DirectĆConnect Installation
For direct-connect installation, connect the control coprocessor to a PLC-5
programmable controller (with expansion port) using a connector header.
Then, install the control coprocessor/PLC-5 programmable controller, as a
unit, into an I/O chassis.
You need the following hardware:
PLC-5 programmable controller with side connector
PLC-5 connector header (1785-CNH/A)
four
screws
four spacers
ESD grounding wrist strap
phillips
screwdriver
Install the Control
Coprocessor