Rockwell Automation 1771-DMC_DMC1_DMC4_DXPS Control Coprocessor User Manual - Manual (Page 93)

Chapter 6
Using the Ethernet Interface
6-12
Figure 6.10
List Ethernet Hardware Address
To download the Ethernet configuration files to the control coprocessor
and initialize the Ethernet port:
1. Select I) Internet Utilities on the PCBridge main menu.
2. Select S) Setup OS-9 Internet on the next menu.
This causes the configuration files to be sent to the control
coprocessor. These files will be stored in the SYS directory on the
control-coprocessor RAM disk.
3. At the OS-9 $ prompt, type startinet and press [Return]
—this invokes the STARTINET procedure file to start up the
Internet software.
You can now use TELNET, FTP, and the socket library for your custom
Internet applications. See the OS-9 Internet Software Reference Manual,
1771-6.4.11, for more information. Also, refer to the README file in the
INET directory for more information.
The file transfer utility (FTP) is used to transfer files to and from remote
systems. There are many FTP commands to facilitate file manipulation
between systems. See the OS-9 Internet Software Reference Manual,
1771-6.4.11, for more information on the FTP utility.
Configuring the
Ethernet Port
Using the OSĆ9/Internet
FTP Utility