Rockwell Automation 1771-DMC_DMC1_DMC4_DXPS Control Coprocessor User Manual - Manual (Page 26)

Chapter 2
Installing the Control Coprocessor
2-8
Connect Control Coprocessor to Programmable Controller
To connect the control coprocessor to the PLC-5 programmable controller:
ATTENTION: Avoid bending pins when installing the
connector header into the PLC-5 programmable-controller side
connector. Also, avoid bending pins when installing the control
coprocessor onto the connector header.
3. Install the connector header into
the programmable controller.
Programmable controller
Shroud
Grip
Ridge
Pins
2. Hold the connector header at the grip
ridge with pins down.
1. Place the PLC-5 programmable controller on a flat, anti-static surface with the side connector face up.
Important: It is important to attach the shroud and the pin
side of the connector header in the designated device.
However, the shroud side and the pin side are not keyed.
19410
19409
4. Place four nylon spacers over the
programmable controller screw holes,
adhesive side down.
5. Install the control coprocessor onto the
shroud side of the connector header.
6. Install four screws, adjust the module
alignment, and then tighten.
FRONTĊPLCĆ5
Programmable
Controller
FRONTĊControl
Coprocessor
Screw
(4 places)
Spacer
(4 places)
Connector Header
(Shroud Side)
19411