Rockwell Automation 1771-DMC_DMC1_DMC4_DXPS Control Coprocessor User Manual - Manual (Page 286)

Using the PCBridge Software
Appendix D
D-8
Once you have logged in and changed to the desired directory:
1. Press [F1] to get the PCBridge main menu.
2. Select the debugger C) Debug .
3. You are prompted for the name of the program module to debug.
Enter
hello .
4. You are prompted for a transfer tag associated with the debug session.
Press
[Return] . See Figure D.6.
Figure D.6
Debug Session
PCBridge Microware’s PC hosted OS-9/680x0 Development System
Enter module name to Debug: hello
The PCBridge software uses Kermit to transfer the module as shown in
Figure D.7.
Figure D.7
Transfer the Module
PCBridge Microware’s PC hosted OS-9/680x0 Development System
Send file HELLO using Kermit
Packets sent : 37
Bytes sent : 1938
Retries : 3
Bytes to send : 7784
Current block window : 33 : 33
8th bit quoting : OFF
Block check type : 1 character checksum
Compression : ON using <~>
Sliding windows : OFF
Long blocks : OFF
Last status message : NAK for packet 7 received.
^F=abort file ^B=abort batch ^K=abort Kermit ^R=retry