Rockwell Automation 1771-DMC_DMC1_DMC4_DXPS Control Coprocessor User Manual - Manual (Page 98)

Chapter 6
Using the Ethernet Interface
6-17
This utility provides user-interface communication to other nodes on the
Internet system. The TELNET utility provides the ability to log on to
remote systems using the control coprocessor and your screen as a terminal
connected to the remote host. See the OS-9 Internet Software Reference
Manual, publication 1771-6.4.11, for more information on the TELNET
utility and commands available.
The following examples show how you might conduct a TELNET session
Important: The following TELNET session is an example only.
It represents how one network is set up and how we accomplished a
TELNET session.
1. At the $ prompt, type telnet and press [Return] . See
Figure 6.17. This starts the interface to the telnet protocol.
2. At the telnet prompt, type help and press [Return] to get a list
of all the available TELNET commands. See Figure 6.17.
Figure 6.17
Starting TELNET and TELNET Help
3. At the telnet prompt, type open and press [Return] to start a
terminal session. See Figure 6.18.
Using the OSĆ9/Internet
TELNET Utility