Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 13)

1 Publication 1738-UM001A-EN-P - February 2005
Chapter
1
Install the ArmorPoint DeviceNet Adapters
This chapter describes how to install and wire your adapter.
Mount the Adapter and
I/O Base
To mount the ArmorPoint adapter on a wall or panel, use the screw
holes provided in the adapter.
A mounting illustration for the ArmorPoint adapter with I/O bases is
shown below.
Install the mounting base as follows:
1. Lay out the required points as shown in the drilling dimension
drawing.
2. Drill the necessary holes for #8 (M4) machine or self-tapping
screws.
3. Mount the adapter and I/O bases using #8 (M4) screws.
4. Ground the system using the ground lug connection in the I/O
base. (The ground lug connection is also a mounting hole.)
See the following sections: Page:
Mount the Adapter and I/O Base 1-1
Set the Node Address 1-2
Wire the DeviceNet Adapters 1-3
Chapter Summary and What’s Next 1-4
43769
4.02 in.
102 mm
1.81 in.
46 mm
Adapter
1.9 in.
47.2 mm
2.0 in.
50 mm
0.87 in.
22 mm
2.0 in.
50 mm
0.87 in.
22 mm
2.0 in.
50 mm
Drilling Dimension Drawing