Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 59)

Publication 1738-UM001A-EN-P - February 2005
Configure the DeviceNet Scanner Subnet 4-7
Following are the remaining configuration windows.
This completes the configuration options. Your scanner must go on
line for configuration changes to take effect.
IMPORTANT: You cannot change any
configuration parameters on this
screen. It is for information purposes
only. These buttons do not apply for
this window but are here to maintain
consistency among the windows.
Use this screen to choose
Automatic Device
Replacement options.
You must have loaded each
device into RSNetWorx for
DeviceNet before you can
Load Device Config using
this button.
ADR window
Summary window