Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 56)

Publication 1738-UM001A-EN-P - February 2005
4-4 Configure the DeviceNet Scanner Subnet
Type the scanner’s name here.
Type a description here (optional).
The scanner’s address must = 0.
This window also shows the
scanner’s device identity. These
fields are read-only.
Use Associate File to
associate this configuration
file with the configuration file
that configures the same 1738
ArmorPoint DeviceNet
scanner (called adapter on the
primary network) for
communication with a master
device on the primary
DeviceNet network.
For more information on the
need to maintain two
configuration files in the same
adapter and the simultaneous
presence of the adapter on
two networks (i.e., DeviceNet
as a slave and PointBus as a
master), see page 4-1.
Click OK to accept the parameters.
IMPORTANT: Configuration changes made
in offline mode do not take
effect until the scanner goes
on line. For more
information on how the
scanner goes on line, see
page 4-8.
Use Clear Association to remove
previously established configuration
file associations that no longer apply
to your scanner.
General window
Device Bridging window