Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 64)

Publication 1738-UM001A-EN-P - February 2005
5-4 Add the ArmorPoint DeviceNet Adapter to the DeviceNet Scanner’s Scanlist
IMPORTANT: The following
configuration parameters:
• Auto Start Mode
• Set Backplane Baudrate
• Set Backplane Autobaud
• AutoAddress Backplane
Modules
should only be used when on line and
should be set to Do Nothing when
Download All Parameters is selected
or when saving to a scanner’s ADR data.
Restore all parameter
default values.
For a description of a
specific parameter, highlight
the parameter below and
click here.
Any parameter with a lock shown before it cannot
be changed.
The values correspond to the I/O connection sizes
from the I/O Data window. They can be uploaded
from an adapter with a downloaded scanlist.
The following screens show how to change the
other parameters.
AutoAddress
Enable or disable autoaddress.
Backplane Baudrate
Backplane Autobaud
Set the backplane baudrate.
Configure backplane modules to autobaud.
Use Associate File to
associate this configuration
file with the configuration file
that configures the same
ArmorPoint DeviceNet
scanner for communication
with ArmorPoint I/O modules.
For more information on the
need to maintain two
configuration files in the same
adapter and the simultaneous
presence of the adapter on
two networks (i.e., DeviceNet
as a slave and Subnet as a
master), see page 5-1.
Use Clear Association to remove
previously established configuration
file associations that no longer apply
to your adapter.
AutoAddress Backplane Modules
Choose the autoaddress.
Auto Start Mode
Note:
The parameters Max Backplane
MACID and Fixed Map Size are found
only in the 1738-ADNX Parameters
window.
Device Bridging window
Parameters window