Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 54)

Publication 1738-UM001A-EN-P - February 2005
4-2 Configure the DeviceNet Scanner Subnet
You must follow these steps during configuration:
1. Add the scanner to your network
2. Add I/O modules to your network
3. Set the scanner’s parameters
4. Go on line
Add the Scanner To Your Network
Follow these steps:
1. Start RSNetWorx for DeviceNet.
2. Add the scanner as shown below.
1. Expand the list of
communication adapters.
2. Select the 1738-ADN12
ArmorPoint Scanner.
The scanner appears
on the network.
3
IMPORTANT
The scanner must always exist on the Subnet at
Node 00.