Rockwell Automation 1738-ADNX ArmorPoint I/O DeviceNet Adapters - Manual (Page 57)

Publication 1738-UM001A-EN-P - February 2005
Configure the DeviceNet Scanner Subnet 4-5
Set the Interscan Delay here.
Set the Foreground to Background
Poll Ratio here. Click here to reset the Interscan Delay
and Foreground to Background Poll
Ratio back to the module default values.
Set the Expected Packet Rate here.
Set the number of Transmit Retries here.
Click Advanced to change the
advanced module settings, as shown in
the following window.
Click OK to accept new
settings.
We recommend you DO NOT change module
settings unless advised to do so by a Rockwell
Automation support representative.
Add and remove I/O modules to and
from the scanlist on this screen.
To set any of the parameters on this
screen (e.g., Node Active) for a
specific module, first add the module
to the scanlist and then highlight the
module to make specific changes.
Click Automap on Add so a
checkmark appears to automap I/O
data when adding modules.
Click Edit I/O Parameters to edit
the module’s I/O parameters, as
shown below.
Click on the appropriate I/O data
transmission method (e.g., Polled) and
make other appropriate I/O parameter
changes on this screen.
Click OK when finished.
Choose Electronic Key
parameters for each module.
Module window
Add modules to or remove
modules from the scanlist.
Advanced window accessed from
Module window
Scanlist window
Edit I/O Parameters window
accessed from Scanlist window