Set the linking device network address, Hardware switches location, Set the controlnet node address – Rockwell Automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATION Fieldbus Linking Device User Manual
Page 19
Advertising
Rockwell Automation Publication 1788-UM057B-EN-P - September 2014
17
Installation
Chapter 1
Set the Linking Device
Network Address
This section describes the network address switches.
Hardware Switches Location
The hardware switches are located under the front cover of the linking device.
Use the Page button to toggle between different diagnostics on the display.
Set the ControlNet Node Address
To set the ControlNet node address of the 1788-CN2FFR linking device, use the
hardware switches behind the front cover.
Advertising
This manual is related to the following products: