Set the ethernet/ip address – Rockwell Automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATION Fieldbus Linking Device User Manual
Page 20
Advertising
18
Rockwell Automation Publication 1788-UM057B-EN-P - September 2014
Chapter 1
Installation
Set the EtherNet/IP Address
The linking device ships with BOOTP enabled. To set the IP address of the
1788-EN2FFR linking device, use a BOOTP server or use the hardware switches.
IMPORTANT
Power down the linking device before changing the Ethernet switch settings.
The IP address is set during powerup.
Advertising
This manual is related to the following products: