Rockwell Automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATION Fieldbus Linking Device - Manual (Page 40)

38 Rockwell Automation Publication 1788-UM057B-EN-P - September 2014
Chapter 2 Set Up in the Studio 5000 Logix Designer Application
Adjust Block Parameters
To change the parameters of a block, right-click
the title portion of the block and choose
Parameters.
To enable a parameter for editing, click the box in
the En column. A green check mark indicates the
parameter is enabled for editing. Different
parameters will have different classes as shown in
Table 4 .
Table 4 - Parameter Class Descriptions
1. Click a parameter that is enabled for editing to display a list of options to
choose from.
2. Select a new value in the pop-up dialog box and click OK.
Icon Parameter Class Description
Configurable parameter but non output
Input port
Read-only
Tune
Output port
Alarm
Parameter help (provides information about the parameter)